"Full paint correction" is not a scope. A stage count is. This is what each stage does to the clear coat, and how to tell whether a quote is real.
Modern paint is a base colour under a clear coat. Swirls, holograms, water spots and light scratches are defects in that clear coat, and polishing removes a few microns of it to level the surface.
That is the whole trade: you are sanding the coat by microns until the defect is gone, then refining the surface so it reflects cleanly. Take off too much and the panel has no protection left.
A single pad and polish combination that removes light swirls and lifts gloss. It is the right answer for a car with mild marring and healthy paint, and it is priced lower because it is fewer passes.
One stage will not remove deeper defects, and it leaves a small amount of the fine haze that the cut itself created. On a light-coloured car that is invisible; on black it is not.
A cut first - firmer pad, compound - then a refinement with a softer pad and a finishing polish to remove the hazing the cut leaves. More hours, more gloss, and the only way to get a true finish on dark paint.
Two stages is also what a coating job normally needs, because a coating magnifies whatever the surface looks like underneath it.
Curbside Mobile Detailing publishes paint correction at $700 for a small vehicle (sedan or coupe) and $900 for a midsize (five-passenger SUV). Those are the numbers this market actually lists, and they sit above the detailing packages because correction is measured in machine hours.
If a quote is far below those figures, ask what stage count it covers and how many hours are being spent. A one-stage job sold as full correction is the most common mismatch in this trade.
Scratches through the clear coat into the colour or primer; stone chips; clear-coat failure - peeling, clouding, white patches; rust; dents and panel damage; and deep etching from sap or droppings that has eaten through the coat.
A detailer should measure paint depth and say which category a mark falls into before polishing. That reading is the difference between a professional and a person with a machine.
Correction lasts until new damage is done, and the damage is almost always washing. Two buckets, a grit guard, a clean microfibre per panel and a rinse before contact are the whole routine. A sealant or a coating on top makes each wash safer.
A coating is published from $1,199 for three years at Deluxe Detailing OH. Coating over uncorrected paint locks the swirls in, which is why the two are normally booked together.
The Columbus weather does the work for the swirls. Salt and grit come off tyres through four months of the year and land on lower panels, and every wipe takes some of that grit across the coat. Spring pollen adds a second abrasive layer that a dry wipe drags over the paint.
Add a Columbus summer of tree sap and droppings in the canopy neighbourhoods and a correction by year five is normal rather than a sign of neglect. Cars that live in garages and are washed by hand reach year ten without it.
A paint-depth gauge gives a micron figure per panel. A repainted panel reads differently from a factory panel, and a panel that has been polished hard in the past reads thin. That reading decides whether a cut stage is safe on that panel.
Ask for the readings in the quote for a two-stage job. A detailer who cannot show them is guessing with someone else's paint.
Curbside Mobile Detailing publishes $700 for a small vehicle and $900 for a midsize. The price is machine hours, so it scales with size and defect.
For light swirls on healthy paint, yes. Dark paint or deeper defects need two stages to remove the haze the cut leaves.
Only the ones in the clear coat. A scratch you can feel with a fingernail is usually through it and needs touch-up or paint.
Rarely - a correction can last the life of the car if the washing is done properly. Repeated polishing on the same panel removes clear coat each time.
Interior work is where the hours go in Columbus, because winter salt and pet hair live in the carpet.
A hand wash and a protectant is the cheapest thing on a Columbus price list and the one that prevents the expensive work.
Mobile detailing brings the water, the power and the equipment to the car. It works if the car can sit in one place.
A coating is a hard, slick layer over the clear coat. It lasts years, but only if the paint under it was corrected first.
Paint correction removes defects from the clear coat. It does not add paint, and it cannot fix what is through the clear coat.
Wax is the cheapest protection you can put on paint, and in Columbus it has two hard deadlines a year.
Vacuuming lifts loose dirt. Extraction pulls out what has soaked into the foam - and in an Ohio winter, that is mostly salt water.
Yellow headlights are a UV problem, not a dirt problem. Wet sanding takes the oxidised layer off; the clear coat is what stops it coming back.
A complete auto detail cleans and protects the inside and the outside in one visit. The price depends on vehicle class more than on anything else.
A three-row SUV or a pickup is not a bigger car. It is a different job, and Columbus shops price it that way.
Car Detailing in Columbus, OH - costs, water and soil notes.
Car Detailing in Dublin, OH - costs, water and soil notes.
Car Detailing in Westerville, OH - costs, water and soil notes.
Car Detailing in Hilliard, OH - costs, water and soil notes.
Car Detailing in Gahanna, OH - costs, water and soil notes.
Car Detailing in Grove City, OH - costs, water and soil notes.
Car Detailing in Upper Arlington, OH - costs, water and soil notes.
Car Detailing in Powell, OH - costs, water and soil notes.